Table of Contents

On-Screen Takeoff Takeoff Boost™ Service Update Release Notes (09-23-2024) - OST DPC

Views: 1990 Last Updated: 11/05/2024 02:43 pm	0 Rating/ Voters
Be sure to rate this article 5 Stars if you find it helpful!

Improvements

Improved detection for angled walls and walls on rotated plans

Examples

Before

Before the update, Takeoff Boost missed several sections of angled wall takeoff

Notice in the bottom-left corner, the Storage room was not takeoff off. Also missed was a section of exterior wall (upper-right), and most of the room dividers.

After

After the update, Takeoff Boost successfully measured all the angled walls

After the update, the takeoff is much more complete. Some Wall Type re-assignment may be necessary, see Related Article for guidance on fixing that.

Before

Before the update, Takeoff Boost missed several sections of angled wall takeoff

Quite a bit of the angled wall takeoff was missed.

After

After the update, Takeoff Boost successfully measured all the angled walls

There is still a little clean-up to do, review Related Articles for assistance.

Before

Before the update, Takeoff Boost missed several sections of angled wall takeoff

Again, prior to this update, Takeoff Boost missed the entire wall toward the top and two of the room dividers.

After

After the update, Takeoff Boost successfully measured all the angled walls

Minimal changes are required to complete the takeoff after this Service Update.