Table of Contents

Reviewing and Fixing Takeoff Boost Results - Partial walls and inaccurate walls drawn

Views: 112 Last Updated: 09/06/2024 10:35 am	0 Rating/ Voters
Be sure to rate this article 5 Stars if you find it helpful!

Note

As this technology is leading-edge, we feel it provides a great deal of value in its current state, however we are dedicated to improving the performance and results of Takeoff Boost with future iterations.

Issue

Sometimes, walls drawn by Takeoff Boost are simply too incorrect to use because adjusting the takeoff would take more time than simply deleting and redrawing from scratch.

Takeoff Boost walls need to be redrawn because adjustments would take longer

Resolution

The resolution is to use the Select Tool the select tool is an upward pointing arrow tilted slightly left and draw a box around all the affected takeoff and delete it (alternately, if all the takeoff drawn on the page is incorrect, you can select all takeoff for a single Condition by right-clicking on the Condition and then "Select Objects" and then delete. See Related Articles for details.

Takeoff Boost walls need to be adjusted to match the angle and size of walls on the plan

Then, using the Condition(s) that Takeoff Boost created, redrawn the takeoff manually. See Related Articles for details on how to draw Linear takeoff.

Warning

When deleting takeoff, be sure the takeoff is selected/active, no the Condition - if you delete a Condition, you could be deleting takeoff on other Pages. See Related Articles for more information.