| |
| |
OST - 10.05.02 How Condition and Typical Group Results Change After Placing Typical Group Markers
| Views: 906 Last Updated: 11/03/2022 02:45 pm |
0 Rating/ Voters
|
 |
| Be sure to rate this article 5 Stars if you find it helpful! |
As you drop Typical Group Markers on your plans, the Results for the Conditions used within the Typical Group Frame, and the Typical Group itself update.
Conditions and Typical Group Results
In the example below, one (1) Typical Group Marker is placed on the page.
- Qty 1 for Typical Group 1 increases by 1
- Quantities for the Conditions Interior Walls and LH Door increase according to the takeoff contained within the frame (they increase in this example, however, you can set takeoff inside the Typical Group Frame to "negative" which would reduce the Condition's Page and cumulative Results. See Related Articles for details on "negative" takeoff.)
When you delete a Typical Group Marker(s), the quantities for that Typical Group, and any associated Conditions, are adjusted accordingly.
|
|
|
Manually Setting the Number of Times a Typical Group Occurs at a Marker