Table of Contents

On-Screen Takeoff - 10.05.01 Manually Setting the Number of Times a Typical Group Occurs at a Marker - OST

Views: 621 Last Updated: 11/12/2024 01:23 pm	0 Rating/ Voters
Be sure to rate this article 5 Stars if you find it helpful!

If you know a Typical Group repeats a set number of times on a page, you can manually enter the count.

First, place a single Typical Group Marker on the page (see previous article for details)
Switch to the Select Tool
Select the Typical Group Marker
Right-click and select Set Typical Group Marker Count

the select tool button is an upward pointing arrow angled slightly to the right

Enter a value for the number of times this Typical Group occurs on this page - for example, 20 (this doesn't add 20 additional Markers, this sets the total count for this Marker to 20... other markers, even for the same Typical Group, are unaffected).

right-click on a typical group marker and select set count from the context menu

Note

After entering the 20, the Total Count for this Typical Group Marker is 20 (not 21) and there are 20 takeoff markers on the page. They are stacked so it may look like only one is there, but if you click on the stack and move one off, you will see the rest of the markers are still stacked in the original location.

after setting the count, all markers are stacked on top of each other

This image shows how the stacked markers can be moved and rearranged as needed...

you can pull markers from the stack to place them anywhere on the plan

Placing Typical Group Markers

How Condition and Typical Group Results Change After Placing Typical Group Markers

OST - 09.01 Selecting, Editing, and Deleting Takeoff and Annotation