Table of Contents

On-Screen Takeoff - 06.01.03 Verifying the Scale of a Plan - OST

Views: 924 Last Updated: 11/08/2024 01:45 pm	0 Rating/ 1 Voters
Be sure to rate this article 5 Stars if you find it helpful!

After you've set (or calculated) the scale for a Page, you must verify, or double-check, it to make sure it is correct (especially important if you are using the scale shown on the Plan).

Caution

Be sure to verify the scale horizontally and vertically - some images are not scaled the same on both axes - these pages are not compatible with On-Screen Takeoff.

To verify scale,

Locate and zoom into a known dimension line on the page (the longer, the better)

locate a labeled or known linear on the plan to verify

Select the Dimension tool from the Annotation toolbar
Measure the known linear (zoom in to be as precise as possible)

dimension line drawn next to a known-length linear on the plan

The dimension line drawn should be the same as on the plan - if not, you must Calculate Scale (see previous article). If you Calculated the Scale, try to be more careful when drawing the measuring line, and choose the longest "known linear" you can find on the drawing.

Be sure to Set/Calculate and Verify Scale on any Page on which you are going to draw takeoff.

So, speaking of drawing takeoff, let's get to it!

Calculating Page Scale

Drawing Takeoff (aka "taking off plans", aka "quantity surveying", aka "measuring")