Table of Contents

On-Screen Takeoff - Measuring the Surface Area of Pipes or Ducts - OST

Views: 1026 Last Updated: 11/06/2024 02:15 pm	0 Rating/ Voters
Be sure to rate this article 5 Stars if you find it helpful!

Question

Can I measure surface area of round pipes with On-Screen Takeoff® (or any Takeoff product) for example, to determine the surface area needed for insulation?

Answer

Yes!

Start by determining the diameter (size) of the pipe - in our example we will use a 5" pipe.

You will need to calculate the circumference of the pipe by multiplying its diameter by Pi (3.1416 is close enough) - in our example we get 15.708 (5 x 3.1416 = 15.708)

Create a Linear Condition (OST is shown below, but the concept is the same for any Takeoff application).

In the Condition Properties window enter ¼ of the circumference, 3.927 (15.708/4 = 3.927), as the Height and Thickness (Width).

Condition Properties set up to calculate Surface Area of Pipes-Ducts

Set the first Quantity to Length, so you get the total RUN value.

Set the second Quantity to Surface area (all side/duct) - This calculates Height x Width x Length, which is the same as Circumference x Length.