On-Screen Takeoff Takeoff Boost™ Service Update Release Notes (2024-09) - OST DPC

AA-05004

Improvements

  • Improved detection for angled walls and walls on rotated plans

Examples

BeforeAfter
Before the update, Takeoff Boost missed several sections of angled wall takeoff 

Notice in the bottom-left corner, the Storage room was not takeoff off.
Also missed was a section of exterior wall (upper-right), and most of the room dividers.		   After the update, Takeoff Boost successfully measured all the angled walls

After the update, the takeoff is much more complete.
Some Wall Type re-assignment may be necessary, see Related Article for guidance on fixing that.
  Before the update, Takeoff Boost missed several sections of angled wall takeoff

Quite a bit of the angled wall takeoff was missed.		   After the update, Takeoff Boost successfully measured all the angled walls

There is still a little clean-up to do, review Related Articles for assistance.
  Before the update, Takeoff Boost missed several sections of angled wall takeoff

Again, prior to this update, Takeoff Boost missed the entire wall toward the top and two of the room dividers.		   After the update, Takeoff Boost successfully measured all the angled walls

Minimal changes are required to complete the takeoff after this Service Update.